The eGrip II Light which is a new version of eGrip II is made of a very lightweight alloy coated with a special wear-resistant "embossed finish". Compare to eGrip II, the Light version features top refilling which means that you simply need to remove the top section of instead of having to unscrew the atomizer.
The eGrip II Light comes with V4.03 firmware and an RTC (Real Time Clock) screen. Further, users can enjoy the TFTA-Tank technology with two batteries in a single device.
The eGrip II Light offers you the ultimate vaping experience thanks to the NotchCoilTM 0.25-Ohm DL coil. Further, you can use the traditional 1.5-Ohm coil. The large 0.96-inch OLED screen featuring a clock and the different colours of the liquid tank make up a practical device that meets the needs of demanding users. As a standard, the eGrip II comes with upgradeable firmware to allow enjoying all future upgrades.
The set includes:
1 * eGrip II Light
1 * NochCoilTM 0.25-Ohm DL.
1 * BF SS316 0.5-Ohm DL.
1 * BF Clapton 1.5-Ohm MTL.
1 * BF RBA M&L (Vertical)
2 * Mouthpiece
1 * USB cable
1 * Instruction manual
1 * Warranty card
1 * Atomizer adapter
Dimensions: 24mm x 45mm x 100.55mm
Output modes: RTC/ VW/ VT (Ti, Ni, SS316)/ Bypass/ TCR (M1, M2, M3)
Power output: 1-80W
Battery capacity: 2100mAh
Resistance range: 0.05-1.5 Ohms in VT mode/ 0.1-3.5 Ohms in VW/Bypass mode
Temperature range: 100-315 degrees/
Finish: black, orange, red, blue
Further, read the FAQs and answers on e-cigarettes > > >
* The useful life of all batteries is 300 charging cycles. This means that charging for even 5 minutes counts for one charging cycle. To ensure complete charging cycles we recommend using the battery until empty and only then charging. Further, we recommend that you always use two batteries to enjoy complete convenience of use: while one battery is in use, the other is being charged.
* It takes approximately 4 hours to charge a 2100 mAh battery using the 220V USB adapter!